Communications - Scientific Letters of the University of Zilina 2010, 12(4):40-44 | DOI: 10.26552/com.C.2010.4.40-44

Mutual Reciprocal Interconnection of Relations Describing Creep, Yield Stress and Stress Relaxation

Jan Kohout1, Vojtech Hruby2
1 Department of Mathematics and Physics, Faculty of Military Technology, University of Defence, Brno, Czech Republic
2 Department of Mechanical Engineering, Faculty of Military Technology, University of Defence, Brno, Czech Republic

The steady-state creep rate increases with testing temperature according to the Arrhenius law and its increase with applied stress is usually described by the power law. Simple multiplication of these two laws leads to the dependence of steady-state creep rate on both the variables. Apparent activation energy and stress sensitivity parameter perform in the combined law as constants but most measurements show their dependence on some of the variables. An equation respecting these experimental facts and simultaneously also based on the Arrhenius equation and the power law is derived and verified using some published results of creep tests. It can be presented geometrically by hyperbolic paraboloid. Resulting from this equation, the dependence of yield stress on temperature and strain rate and also an equation describing the relaxation curves are deduced.

Keywords: no keywords

Published: December 31, 2010  Show citation

ACS AIP APA ASA Harvard Chicago Chicago Notes IEEE ISO690 MLA NLM Turabian Vancouver
Kohout, J., & Hruby, V. (2010). Mutual Reciprocal Interconnection of Relations Describing Creep, Yield Stress and Stress Relaxation. Communications - Scientific Letters of the University of Zilina, 12(4), 40-44. doi: 10.26552/com.C.2010.4.40-44
Share...
Download citation
  • BibTeX (.bib)
  • Bookends (.ris)
  • EasyBib (.ris)
  • EndNote (.enw)
  • EndNote 8 (.xml)
  • ISI WoS (.isi)
  • Medlars (.medlars)
  • Mendeley (.ris)
  • MODS (.xml)
  • Papers (.ris)
  • RefWorks (.txt)
  • RefManager (.ris)
  • RIS (.ris)
  • MS Word (.xml)
  • Zotero (.ris)
    • Open full article

    References

    1. CADEK, J.: Creep in Metallic Materials, Prague : Academia & Amsterdam : Elsevier, 1988.
    2. GAROFALO, F.: Fundamentals of Creep and Creep Rupture in Metals, New York : Macmillan, 1965.
    3. SHERBY, O.D.: Acta Met., 1962, vol. 10, p. 135. Go to original source...
    4. KOHOUT, J.: New Description of Steady-state Creep Rate, Yield Stress, Stress Relaxation and their Interrelation, Materials Structure & Micromechanics of Fracture IV (Materials Science Forum), 2005, vol. 482, pp. 319-322. Go to original source...
    5. SKLENICKA, V., KUCHAROVA, K., DLOUHY, A., KREJCI, J.: In: Materials for Advanced Power Engineering, Part I (ed. Coutsouradis, D.), Dordrecht : Kluwer Academic Publishers, 1994, p. 435. Go to original source...
    6. SKLENICKA, V., KUCHAROVA, K., KLOC, L.: In: Materials for Advanced Power Engineering 1998, Part I (eds Lecomte-Beckers, J. et al.), Julich : Forschungszentrum Julich, 1998, p. 233.
    7. VLACH, B., HOLZMANN, M., MAN, J.: Zvaranie [Welding], 2/1986, vol. 35, p. 35, ISSN 0044-5525 (in Czech).
    8. MEYERS, M.A.: Dynamic Behavior of Metals, New York : Wiley, 1994. Go to original source...
    9. LI, J.C.M.: Canadian Journal of Physics, 1967, Vol. 45, p. 493. Go to original source...
    10. KOHOUT, J.: Prediction of Temperature and Strain Rate Dependence of Yield Stress Using Test of One Bar at Room Temperature (in Czech), Materials Engineering, Vol. 4, 1997, pp. 1-9, ISSN 1335-0803.

    This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.


    Return to the content