Communications - Scientific Letters of the University of Zilina 2003, 5(2):26-28 | DOI: 10.26552/com.C.2003.2.26-28
Investigation of Local Mechanical Properties of Al-Cu-Li Alloys by Acoustic Microscope
- 1 University of Zilina, Department of Physics, Slovakia
- 2 University of Oxford, Department of Materials, UK
- 3 University of Trencin, Faculty of Industrial Technologies, Department of Physical Engineering of Materials, Puchov, Slovakia
The reflected scanning acoustic microscope was used for investigation of elastic properties of extruded Al-Cu-Li alloys. The local sound velocity and attenuation were measured by the V(z) curve method. The results show strong anisotropy of material due to extrusion of the sample.
Keywords: no keywords
Published: June 30, 2003 Show citation
| ACS | AIP | APA | ASA | Harvard | Chicago | Chicago Notes | IEEE | ISO690 | MLA | NLM | Turabian | Vancouver |
Berezina, S., Kolosov, O., & Slabeycius, J. (2003). Investigation of Local Mechanical Properties of Al-Cu-Li Alloys by Acoustic Microscope. Communications - Scientific Letters of the University of Zilina, 5(2), 26-28. doi: 10.26552/com.C.2003.2.26-28
References
- ZININ, P. V.: Quantitative Acoustic Microscopy of Solids. Handbook of Elastic Properties of Solids, Liquids, and Gases. Volume I: Dynamic Methods for Measuring the Elastic Properties of Solids. M. Levy, H. Bass, R. Stern and V. Keppens. New York, Academic Press. (2001), pp. 187-226.
Go to original source... - KOŠTIAL, P., BEREZINA, S., SLABEYCIUS, J.: Utilisation of Ultrasonic Waves in the Study of Surfaces and Interfaces, Univ. of Zilina Edition, Žilina, 1998 (in Slovak)
- WEGLEIN R. D., WILSON R. G.: Characteristics Material Signatures by Acoustic Microscopy, Electr. Lett., 14, (1978), 352 Go to original source...
- ATALAR A.: A Physical Model for Acoustic Signatures, J. Appl. Phys., 50, (1979), 8237 Go to original source...
- PARMON W., BERTONI H. L.: Ray Interpretation of the Material Signature in the Acoustic Microscope, Electr. Lett., 15, (1979), 684 Go to original source...
- BEREZINA S. I.: Application of acoustic microscope for determining the orientation dependences of SAW velocity in crystals. Proc. of XI Sov. Conf. on acoustoelectronics and quantum acoustics (Dushanbe, May 1981), part 1, p.84-85 (in russian)
- KUSHIBIKI, J., OHKUBO, A., CHUBACHI. N.: Anisotropy Detection in Sapphire by Acoustic Microscopy using Line-Focus-Beam, Electton.Lett, 17, (1981), 534 Go to original source...
- BRIGGS, A., KOLOSOV, O.: Anisotropic elastic characterization of surfaces from 2 MHz to 20 MHz. Ultrasonics, 36, (1998), p.317-321. Go to original source...
- STARÝ, V., MACEK, K.: Composition US. Size Distribution of Intermetallic Phases in Al Alloys(Al-Cu-Li-Zr). Journal of Computer Assisted Microscopy. 9, No. 1, (1998) p. 45.
- CIESLAR, M., VOSTRÝ, P., OČENÁŠEK, V., STULIKOVÁ, I.: Inhomogeneity of Mechanical Properties and Deformation Instabilities in Al-Cu-Li-Mg Alloy, Material Science and Eng. A234-236 (1997), 790-793. Go to original source...
- TARDY F., NORDY, M. H., PARADIS L., BABOUX, J. C.: Material Surface Characterization by a Rayleigh Velocity Measurement, Proc. of Ultrasonics World Congress 1995, Berlin 1995, 451.
- EYRAUD, V., NADAL, M. N., GONDARD, C.: Texture measurement of shaped Materials by Impulse Acoustic Microscopy, Ultrasonic World Congress 99, Book of Abstracts.
This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.