Communications - Scientific Letters of the University of Zilina 2022, 24(3):B158-B169 | DOI: 10.26552/com.C.2022.3.B158-B169
Economic and Environmental Benefits of Using Cavitation Treated Fuel in Vehicles of Internal Combustion Engines
- 1 Department of Descriptive Geometry and Engineering Graphics, Institute of Applied Mathematics and Fundamental Sciences, Lviv Polytechnic National University, Lviv, Ukraine
- 2 Department of Ecology and Sustainable Environmental Management, Viacheslav Chornovil Institute of Sustainable Development, Lviv Polytechnic National University, Lviv, Ukraine
- 3 Department of Organic Products Technology, Institute of Chemistry and Chemical Technologies, Lviv Polytechnic National University, Lviv, Ukraine
- 5 Department of Human Resourse Management and Adminislration, Lviv Polytechnic National University, Lviv, Ukraine
The results of an experimental study of efficiency of the cavitation treatment of a fuel mixture, based on A-95 gasoline and distilled water, for automobile internal combustion engines are presented. Cavitation treatment of this fuel mixture at a percentage of water/gasoline of 17/83 % allows increasing the cost of gasoline up to 15-20 % when operating engines on flat and sloping sections of roads and in traffic jams. Due to the cavitation treatment, the engine power is reduced by only 6/7 %. The design of the created automobile electromagnetic vibrating cavitator is described. Its application will not only save fuel, but increase the completeness of combustion of water-gasoline fuel mixture, i.e. improve the environment, as well %.
Keywords: cavitation disturber, electromagnetic drive, gasoline economy, completeness of fuel combustion ecology
Received: August 10, 2021; Accepted: January 20, 2022; Prepublished online: March 25, 2022; Published: July 1, 2022 Show citation
ACS | AIP | APA | ASA | Harvard | Chicago | Chicago Notes | IEEE | ISO690 | MLA | NLM | Turabian | Vancouver |
References
- SHATOKHA, V., MATUKHNO, E., BELOKON, K., SHMATKOV, G. potential means to reduce CO2 emissions of iron and steel industry in Ukraine using best available technologies. Journal of Sustainable Metallurgy [online]. 2020, 6(3), p. 451-462. ISSN 2199-3823. Available from: https://doi.org/10.1007/s40831-020-00289-0
Go to original source...
- MALOVANYY, M., ZYCZYNSKA, A. Minimization of energy consumption for heating houses by thermal modernization (on the example of educational buildings) / Minimizatsiia enerhovytrat na opalennia budynkiv shliakhom termomodernizatsii (na prykladi navchalnykh korpusiv) (in Ukrainian). Ekolohichna Bezpeka ta Zbalansovane Resursokorystuvannia [online]. 2016, 2, p. 135-140. ISSN 2415-3184. Available from: http://library.nung.edu.ua/ekolog%D1%96chna-bezpeka-ta-zbalansovane-resursokoristuvannya.html
- VOYTOVYCH, I., MALOVANYY, M., ZHUK, V., MUKHA, O. Facilities and problems of processing organic wastes by family-type biogas plants in Ukraine. Journal of Water and Land Development [online]. 2020, 45(IV-VI), p. 185-189. ISSN 2083-4535. Available from: https://doi.org/ 10.24425/jwld.2020.133493
Go to original source...
- MALOVANYY, M., TYMCHUK, I., BALANDIUKH, IU., SOLOVIJ, KH., ZHUK, V., KOPIY, M., STOKALYUK, O., PETRUSHKA, K. Optimum collection and concentration strategies of hydrobionts excess biomass in biological surface water purifying technologies. Environmental Problems [online]. 2021, 6(1), p. 40-47. ISSN 2414-5955. Available from: https://doi.org/10.23939/ep2021.01.040
Go to original source...
- NYKYFOROV, V., MALOVANYY, M., KOZLOVSKA, T., NOVOKHATKO, O., DIGTIAR, S. The biotechnological ways of blue-green algae complex processing. Eastern-European Journal of Enterprise Technologies [online]. 2016, 5(10), p. 11-18. ISSN 1729-3774. Available from: https://doi.org/10.15587/1729-4061.2016.79789
Go to original source...
- MALOVANYY, M., ZHUK, V., NYKYFOROV, V., BORDUN, I., BALANDIUKH, J., LESKIV, G. Experimental investigation of Microcystis aeruginosa cyanobacteria thickening to obtain a biomass for the energy production. Journal of Water and Land Development [online]. 2019, 43(X-XII), p. 113-119. ISSN 2083-4535. Available from: https:// doi.org/10.2478/jwld-2019-0069
Go to original source...
- LUHOVSKOI, A. F. The use of piezoelectric converters as a way to improve the systems for the preparation and supply of fuel to the internal combustion engine / Primenenie pezoelektricheskih preobrazovateley kak put sovershenstvovaniya sistem podgotovki i podachi topliva v DVS (in Russian). Vestnik Natsionalnogo Tehnicheskogo Universisteta Ukrainyi "KPI". Mashinostroenie. 1997, 32, p. 34-38. ISSN 2305-9001.
- LUHOVSKOI, A. F. Preparation of a fuel mixture in an internal combustion engine using ultrasound / Podgotovka toplivnoy smesi v DVS s pomoschyu ultrazvuka (in Russian). Vestnik Natsionalnogo Tehnicheskogo Universisteta Ukrainyi "KPI". Mashinostroenie. 1997, 32, p. 209-213. ISSN 2305-9001.
- LUHOVSKOI, A. F. Ultrasonic spraying in fuel-air mixture preparation systems / Ultrazvukovoe raspyilenie v sistemah podgotovki toplivno-vozdushnoy smesi (in Russian). Tekhnika v Silskohospodarskomu Vyrobnytstvi, Haluzeve Mashynobuduvannia, Avtomatyzatsiia. Zbirnyk Naukovykh Prats Kirovohradskoho Derzhavnoho Tekhnichnoho Universytetu. 2000, 7, p. 30-33. ISSN 2409-9392.
- LUHOVSKOI, A. F., CHOPNYIY, V. I., EPEMENKO, A. I. Preparation of a fuel mixture in carburetor power systems for internal combustion engines using an ultrasonic dispenser with radial-bending vibrations / Podgotovka toplivnoy smesi v kapbyupatopnyih sistemah pitaniya DVS s pomoschyu ultpazvukovogo dispepgatopa s padialno-izgibnyimi kolebaniyami (in Russian). In: International Scientific and Technical Conference Ppohpesyvna Tekhnika i Tekhnolohiia Mashynobuduvannia, Ppyladobuduvannia i Zvapiuvalnoho Vyrobnytstva: proceedings. Vol. 3. 1998. p. 341-346.
- CHORNYI, V. I., LUHOVSKYI, O. F., PRYLYPKO, Y. S. Ultrasonic fuel treatment device in internal combustion engines/ Prystrii ultrazvukovoi obrobky palyva v dvyhunakh vnutrishnoho zghoriannia (in Ukrainian) [online]. Patent Ukrainy UA 42827. Available from: https://base.uipv.org/searchINV/search.php?action= viewdetails&IdClaim =17353
- FEDOTKIN, I. M., GULYIY, I. S. Cavitation: Cavitation technique and technology, their use in industry / Kavitatsiya: Kavitatsionnaya tehnika i tehnologiya, ih ispolzovanie v promyishlennosti (in Russian). Kyiv: Polihrafknyha, 2000. ISBN 5-7763-2417-3.
- SHEVCHUK, L. I., STARCHEVSKYI, V. L. Cavitation. Physical, chemical, biological and technological aspects / Kavitatsiia. Fizychni, khimichni, biolohichni ta tekhnolohichni aspekty (in Ukrainian). Lviv: Vydavnytstvo Lvivskoi politekhniky, 2014. ISBN 978-617-607-666-7.
- SHEVCHUK, L. I., AFTANAZIV, I. S., STROHAN, O. I., STARCHEVSKYI, V. L. Low-frequency vibration-resonant cavitators / Nyzkochastotni vibrorezonansni kavitatory (in Ukrainian). Lviv: Vydavnytstvo Lvivskoi politekhniky, 2013. ISBN 978-617-607-509-7.
- LUGOVSKOY, A. F., CHUHRAEV, N. V., CHORNYIY, V. I., PRILIPKO, Y. S. Ultrasonic cavitation technologies in mechanical engineering and medicine / Ultrazvukovyie kavitatsionnyie tehnologi v mashinostroenii i meditsine (in Russian). Vestnik Natsionalnogo Tehnicheskogo Universisteta Ukrainyi "KPI". Mashinostroenie. 2006, 48, p. 228-233. ISSN 2305-9001.
This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.