Communications - Scientific Letters of the University of Zilina 2008, 10(3):72-76 | DOI: 10.26552/com.C.2008.3.72-76
Two and Three-Revolution Cyclical Surfaces
- 1 Institute of Technology, Economics and Management in Civil Engineering, Civil Engineering Faculty, Technical University of Kosice, Slovakia
The creation of two-revolution and three-revolution cyclical surfaces is presented in the paper. Classification and vector equations of the surfaces are given. The surfaces are created by translation of the circle along the curves and its centre is on the curve. The curves are created by revolution of a point about any edge of the trihedron of the previous curve and this trihedron moves simultaneously along this curve. All specific forms of surfaces are illustrated in figures visualized in Maple.
Keywords: no keywords
Published: September 30, 2008 Show citation
References
- OLEJNIKOVA, T.: Straight-lines Spiral-rotary Planes (in Slovak), Proc. of 26. konference o geometrii a pocitacove grafice, 2006, Nove Mesto na Morave, CR, 2006, p. 15-28, ISBN 80-7040-902-9.
- OLEJNIKOVA, T.: Straight-lines Spiral-rotary Planes II (in Slovak), Proc. of 6th International Conference APLIMAT 2007, Bratislava, 2007, p. 231-236, ISBN 978-80-969562-4-1
- KOHOUT, V.: Differential Geometry (in Czech), SNTL-Publishers of Technical Literature, Praha, 1971.
- GRANAT, L., SECHOVSKY, H.: Computer Graphics (in Slovak), SNTL - Publishers of Technical Literature, Bratislava, 1974
This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.